Mill performance is based on mill diameter and length only increases or decreases capacity. The Slice Mill is simply a mill of the same diameter as the production mill but much shorter. A Slice Mill of 72 diameter by 12 wide would replicate the result of a normal production, mill 72 in diameter as 120 long.
Ball milling boasts several advantages over other systems: the cost of installation and grinding medium is low; the capacity and fineness can be adjusted by adjusting the diameter of the ball; it is suitable for both batch and continuous operation; it is suitable for open and closed circuit grinding; it is applicable for materials of all degrees of hardness.Wikipedia · Text under CC BY SA license
Ball Mill Design A survey of Australian processing plants revealed a maximum ball mill diameter of 5.24 meters and length of 8.84 meters . Autogenous mills range up to 12 meters in diameter. The length to diameter ratios in the previous table are for normal applications.
In Grinding, selecting the correct or optimum ball size that allows for the best and optimum/ideal or target grind size to be achieved by your ball mill is an important thing for a Mineral Processing Engineer AKA Metallurgist to do. Often, the ball used in ball mills is oversize just in case. Well, this safety factor can cost you much in recovery and/or mill liner wear and ...
A) Total Apparent Volumetric Charge Filling including balls and excess slurry on top of the ball charge, plus the interstitial voids in between the balls expressed as a percentage of the net internal mill volume . B) Overflow Discharge Mills operating at low ball fillings slurry may accumulate on top of the ball charge; causing, the Total Charge Filling Level to ...
diameter cylinder length cylinder to floor height length depth hatch weight BM 16 16 2.1 9.6 1.3 4.0 0.5 322 46 43 15 21 18 42 52 43 5.3 x 5.3 780 BM 26 26 3.5 16 2.1 6.6 0.9 530 42 39 18 24 18 45 54 43 7.75 x 9.25 1,000 ... Ball Mill Capacity Dimensions 2013.indd
Aug 30, 2019· The size of the ball mainly depends on the particle size of the material to be ground, and the diameter and speed of the mill can be considered appropriately. Formula is an empirical formula for spherical diameter and feed size. dmax The maximum diameter of steel ball, mm; amax the maximum size of feeding granularity, mm.